Intrebare E93

[SergiuJ]

Va salut,

Stie cineva cum se pot programa butoanele de pe oglinda retrovizoare pentru deschiderea usii de la garaj?Multumesc

[vartocp]

Va salut,

Stie cineva cum se pot programa butoanele de pe oglinda retrovizoare pentru deschiderea usii de la garaj?Multumesc

Daca mai ai manualul scrie acolo pas cu pas.Daca nu incearca sa il descarci si sigur ai sa reusesti.Uite ceva in engleza daca te ajuta.

96

Practical interior accessories

Integrated universal remote

control*

The concept

The integrated universal remote control

replaces up to three different hand-held

transmitters for various remote-controlled

equipment such as door openers and

house alarm systems. The integrated universal

remote control registers and stores

signals from the original hand-held transmitters.

The signal of an original hand-held transmitter

can be programmed on one of the

three memory buttons 1. Following that,

each of the devices can be actuated with

the appropriately programmed memory

button 1. The indicator lamp 2 flashes to

confirm transmission of the signal.

If the vehicle is sold, the memory of the buttons

1 should be cleared, refer to page 97.

To prevent possible damage or injury,

before programming or using the integrated

universal remote control, always

inspect the immediate area to make certain

that no people, animals or objects are

within the travel range of the device. Also,

comply with the safety precautions of the

original hand-held transmitter.<

Checking the compatibility

If you see this symbol on the packaging

or in the manual supplied with

the original hand-held transmitter, it

is safe to assume that it is compatible with

the integrated universal remote control.

If you have additional questions,

please consult your BMW center or

call 1-800-355-3515.

You can also visit these websites:

www.bmwusa.com or

www.homelink.com.

HomeLink is a registered trademark owned

by Johnson Controls, Inc.<

Programming

1 Memory buttons

2 Indicator lamp

Fixed-code hand-held transmitter

1. Turn the ignition key to position 2

2. When using for the first time:

Press both outer buttons 1 for approx.

20 seconds until the indicator lamp 2

flashes. The three memory buttons 1

are cleared

3. Hold the original hand-held transmitter

at a distance of approx. 2 in/5 cm to

8 in/20 cm to the memory buttons 1

The required distance between

the hand-held transmitter and the

memory buttons 1 depends on the relevant

system of the original hand-held

transmitter used.<

4. Simultaneously press the transmit button

on the original hand-held transmitter

and the desired memory button 1 on

the integrated universal remote control.

Initially, the indicator lamp 2 flashes

slowly. Release both buttons as soon

as the indicator 2 lamp flashes rapidly. If

the indicator lamp 2 does not flash rapidly

after approx. 15 seconds, change

the distance

5. To program other original hand-held

transmitters, repeat steps 3 and 4.

The corresponding memory button 1 is now

programmed with the signal of the original

hand-held transmitter

Edited March 24, 2010 by vartocp